2004 Kia Sorento

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Prop shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust noisy (8.1.1 (a))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Rear Exhaust system insecure (6.1.2 (a))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Exhaust noisy (8.1.1 (a))

Offside Rear Lower Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Nearside side step missing brackets protruding

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength under sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded across axle (1.1.11 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Parking brake lever has no reserve travel (3.1.6b)