2006 Toyota Aygo

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Lower Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Tyre tread depth below requirements of 1.6mm both sides (5.2.3 (e)) DANGEROUS

Offside Rear Body pillar so insecure that load stability or security is likely to be seriously impaired (6.2.1 (b) (ii)) DANGEROUS

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Stop lamp(s) not working both sids (4.3.1 (a) (ii))

Front Tyre tread depth below requirements of 1.6mm both sides (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

underbody corrosion (front and rear (frames, body and suspension)

Front Anti-roll bar pin or bush excessively worn both sides (5.3.4 (a) (i))

Front Headlamp not working on dipped beam both sides (4.1.1 (a) (ii))

underbody corrosion (front and rear (frames, body and suspension)

Underbody corrosion front to rear

Front Anti-roll bar pin or bush excessively worn both sides (5.3.4 (a) (i))

Front Brake disc significantly and obviously worn both sides (1.1.14 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill corroded (5.3.6 (a) (i))

Underbody corrosion front to rear

both sides inner sills starting to corrode

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill corroded (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill corroded (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded front to rear (1.1.11 (c))

both sides inner sills starting to corrode

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Steering locking device ineffective pin (2.1.3 (d))

Offside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sides (6.2.2 (d) (i))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)

Reverse light not working

Offside Stop lamp not working (1.2.1b)

Reverse light not working

Child seat fitted not allowing full inspection of adult belt

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

slight wear o/s and n/s front discs