2007 Piaggio Vespa

Exhaust silencer slightly loose (8.1.1 (b) (i))

Exhaust noisy (8.1.1 (a))

Front Horn control insecure (7.7 (b))

Front Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Brake effort inadequate at a wheel (1.2.1 (a) (i))

Front Headlamp aim not tested (4.1.2 (b))

Front Headlamp lens seriously defective (4.1.1 (b) (ii))

Front Motorcycle structure joining/attachment plate or fastening insecure (6.1.1 (b) (i))

Rear Brake effort inadequate at a wheel (1.2.1 (a) (i))

Roller brake test brake efficiency less than 27.5% overall (1.2.2 (a) (ii)) DANGEROUS

Registration plate does not conform to the specified requirements (0.1 (d))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Suspension component has wear or play, but not to excess (5.3.3 (d))

Front Suspension arm ball joint worn, but not excessively (5.3.4 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Roller brake test Higher brake efficiency normally obtainable. (3.3.A2b)

Rear Roller brake test Higher brake efficiency normally obtainable. (3.3.A2a)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Exhaust is leaking but is not excessively noisey (7.1.1b)

Steering movement slightly 'notchy' (2.2.1a)

Front Brake lever has inadequate reserve travel (3.1.3b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear position lamp adversely affected by the operation of another lamp (1.1.3b)

Stop lamp affected by the operation of another lamp (1.3.2)

Steering movement slightly 'notchy' (2.2.1a)

Brake lever has inadequate reserve travel (3.1.3b)

Brake pedal has inadequate reserve travel (3.1.3b)

Centre Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Headlamp aim not tested (1.6)

Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Front Tyre has a lump caused by separation or partial failure of its structure (4.1.2a(ii))

Plate brake test Neither brake control achieves an efficiency of 25% (3.3.B2b)

Plate brake test No brake control achieves an efficiency of 30%. (3.3.B2a)

Rear Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Throttle operating incorrectly (6.2.1f)

Front Steering movement slightly 'notchy' (2.2.1a)

Front Steering movement slightly 'notchy' (2.2.1b)

Front suspension has a slightly reduced damping effect (2.3.6c)

Rear shock absorber has a slightly reduced damping effect (2.4.A.3b)

rear swinging arm bushes perishing.