2007 Chevrolet Matiz

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sil (6.2.2 (d) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sil (6.2.2 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Position lamp not working both sides (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement Top mount (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Both outer sills starting to corrode

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Both outer sills starting to corrode

Offside Front Inner Tyre worn close to legal limit/worn on edge replace as soon as possible (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge replace as soon as possible (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Exhaust mounting defective (6.1.2 (a))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

under trays fitted

under trays fitted

Fuel system component leaking (7.2.3)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)