2008 Honda Cg 125-7

Stop lamp switch does not operate in accordance with the requirements Front Brake Switch stays on for a couple seconds after brake released (4.3.2 (a) (i))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Stop lamp switch does not operate in accordance with the requirements Front Brake Switch stays on for a couple seconds after brake released (4.3.2 (a) (i))

Front Brake binding but not excessively (1.2.1 (f))

Front Stop lamp not working (4.3.1 (a) (ii))

Front Stop lamp not working (4.3.1 (a) (ii))

Headlamp aim too high and too far to the right (4.1.2 (a))

Headlamp aim too low (4.1.2 (a))

Rear Stop lamp switch with a delay in operation (4.3.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Brake binding but not excessively (1.2.1 (f))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Steering movement slightly rough. (2.2.1a)

Steering movement slightly stiff (2.2.1b)

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front shock absorber seal failed and leaking oil (2.3.3)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Steering movement slightly rough. (2.2.1a)

Steering movement slightly stiff (2.2.1b)

Drive chain slightly tight (6.2.1d)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) close to minimum limit (3.2A1f(ii))

Drive chain worn but not considered excessive (6.2.1e)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front shock absorber has light misting of stanchion (2.3.3)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre tread not clearly visible (4.1.3(i))

Front Front suspension has severe distortion of a load bearing member or its supporting structure. (2.3.8)

Nearside Front Front suspension assembly component excessively bent (2.3.1)

Offside Front Front suspension assembly component excessively bent (2.3.1)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))