2008 Peugeot 107

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle beam bush mounting (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle beam bush mounting (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources one of two not working (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Horn not working (7.7 (a))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Headlamp insecure (4.1.1 (c))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle beam bush mounting (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle beam bush mounting (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources one of two not working (4.7.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Front Inner Road wheel slightly distorted Both (5.2.2 (c) (i))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Service brake binding but not excessively Both (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill holed (7.1.1 (a) (i))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill holed (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Offside Rear Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Coolant leak ()

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Position lamp not working (4.2.1 (a) (ii))

Offside Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Position lamp not working (4.2.1 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Horn not working (1.6.2a)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Rear Brake pipe excessively corroded into hose (3.6.B.2c)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

cannot see brake pad life.

slight cut on n/s front tyre outer wall

cannot see brake pad life

cannot see pad life

Nearside Front Suspension arm locating pin locking device missing (2.4.G.3b)

Nearside Steering retaining device missing (2.2.C.1g)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

cannot see pad life

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)