2008 Ford Ka

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Arch area (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Offside Front Subframe mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Arch area (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Floor (7.1.1 (a) (i))

Spare wheel carrier insecure (6.1.5 (a))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Inner Suspension component mounting prescribed area is corroded but not considered excessive Wing area (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Parking brake effort low

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Various corrosion spots underbody

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn bottom arm rear bush (5.3.4 (a) (i))

Offside Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill (5.3.6 (a) (i))

Front Exhaust has a major leak of exhaust gases flexi (7.1.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Outer Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

front brake application uneven (3.7.B.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

n/s/r tyre showing cracks on sidewall

o/s/f tyre worn on inner edge

Nearside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

n/s/r tyre showing cracks on sidewall

o/s/f tyre worn on inner edge

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Stop lamp not working (1.2.1b)