2008 Toyota Aygo

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

o/s/f tyre outer wall cut

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Emissions unable to be completed exhaust blowing (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

o/s/f tyre outer wall cut

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both N/S and O/S (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Service brake just met requirements will require adjustment /repair

Front Position lamp not working Both N/S and O/S (4.2.1 (a) (ii))

Nearside Rear Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Upper Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both N/S and O/S (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Service brake just met requirements will require adjustment /repair

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength cill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Child Seat fitted not allowing full inspection of adult belt

Emissions not tested (8.2.1.2 (d))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Headlamp aim not tested (4.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Child Seat fitted not allowing full inspection of adult belt

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin O/s & n/s (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened O/s & n/s (3.5.1i)

Bonnet cannot be secured in the closed position (8.4.1)

x2 nails in offside rear tyre.

both rear tyres slightly perished.

front wiper not clearing 100%.

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)