2006 Mercedes-benz C

Emission control equipment obviously defective (8.2.2.1 (a))

Nearside Front Body insecure (6.2.2 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Bumper damaged and likely to cause injury when grazed or contacted (6.1.4 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn front most arm (5.3.4 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension arm ball joint excessively worn Rear arm (5.3.4 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Centre exhaust mount broken but exhaust is still secure

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust system not adequately supported (7.1.1)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement & offside front (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Tyre worn close to the legal limit (4.1.E.1)

off side front tyre worn on inner edge