2005 Kia Sorento

Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced fuel tank support plate corroded (6.1.1 (c) (i))

Central Rear Vehicle structure has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Central Exhaust system not adequately supported (7.1.1)

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Central Rear Vehicle structure has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)