2008 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Headlamp aim projected beam image is obviously incorrect Both (4.1.2 (c))

Headlamp lens seriously defective Both (4.1.1 (b) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords Both (5.2.3 (d) (i))

Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Both rear outer sills (6.2.2 (d) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Headlamp has a product on the lens but not seriously reducing light output Both Sides (4.1.4 (b))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Headlamp aim not tested (1.8.A.1c)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Offside Front Headlamp aim not tested (1.8.A.1c)

Offside Rear Coil spring not correctly located (2.4.C.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a) DANGEROUS

Offside Front Headlamp not working on dipped beam (1.7.5a) DANGEROUS

o/s/r tyre perishing

Front Headlamp aim too high (1.8)

Nearside Front Headlamp aim too high (1.8)

nearside rear spring lower insulator displaced