2011 Citroen Relay

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Headlamp aim too far to the left (4.1.2 (a))

Offside Headlamp aim too low and too far to the left. (4.1.2 (a))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake pedal anti-slip provision missing (1.1.2 (c))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Play in steering rack inner joint(s) ()

Front Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit brake wear indicator wire (4.11 (c) (ii))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Lower Steering linkage ball joint has slight play (2.1.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake hose slightly chafed (3.6.B.4d)

Upper Stop lamp has light sources not illuminating, but not more than 50% (1.2.1b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)