2005 Honda CG125

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Drive chain sprocket worn, but not excessively BENT (6.1.7 (c) (i))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Drive chain sprocket worn, but not excessively BENT (6.1.7 (c) (i))

Rear Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Shock absorber has a light misting of oil (5.3.2 (b))

Chain guard missing ()

Chain guard missing ()

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Exhaust slightly deteriorated (7.1.1a)

Front Brake lever is short but brake can still be readily applied (3.1.3c)

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Motorcycle structure slightly corroded Swinging arm (6.1.1a)

Rear Drive chain excessively loose (6.2.1d)

Rear Drive chain worn to excess (6.2.1e)

Rear Rear reflector on motorcycle missing (1.4.1)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Drive chain sprocket worn to excess (6.2.1e) DANGEROUS

Exhaust slightly deteriorated (7.1.1a)

Front Brake lever is short but brake can still be readily applied (3.1.3c)

Front Roller brake test indicates a slightly grabbing brake (3.3.A1b)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Motorcycle structure slightly corroded Swinging arm (6.1.1a)

Drive chain excessively loose (6.2.1d)

Drive chain sprocket worn to excess (6.2.1e)

Drive chain worn to excess (6.2.1e)

Front shock absorber seal failed and leaking oil (2.3.3)

Front suspension assembly component missing (2.3.1)

Front suspension has excessive stiffness in the suspension movement. (2.3.6b)

Handlebar deformed (2.1.1b)

Rear Brake lining(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake locking device missing (3.2.A1e)

Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Drive chain excessively loose (6.2.1d)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Tyre has a lump caused by separation or partial failure of its structure (4.1.2a(ii))

Front Wheel has an excessively distorted bead rim. (4.2.2)

Fuel system component insecure (7.2.1b)

Headlamp aim too low (1.6)

Locking devices not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Offside Rear Direction indicator not working (1.5.1c)

Rear Tyre worn close to the legal limit (4.1.3(ii))

advise change front mbrake calieper

advise change handle bars

Rear Tyre worn close to the legal limit (4.1.3(ii))

advise change front mbrake calieper

advise change handle bars

Wheel alignment slightly misaligned. (2.5.1)

front tyre is slightly perished

handle bars are bent

offside front footpeg bent

Drive chain slightly loose (6.2.1d)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

advise clutch lever short

advise off side front foot peg damaged

Drive chain slightly loose (6.2.1d)

advise clutch lever short

advise off side front foot peg damaged

Front Brake master cylinder fluid level low (3.2.B1d)

Front Wheel has a slightly distorted bead rim. (4.2.2)

Rear Exhaust mounting missing (7.1.1c)

advise handle bars bent

advise offside foot rest bent

Front Brake master cylinder fluid level low (3.2.B1d)

Front Wheel has a slightly distorted bead rim. (4.2.2)

advise handle bars bent

advise offside foot rest bent

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Motorcycle structure excessively corroded (6.1.1a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)