2006 Honda Accord

Front Windscreen washer not working (3.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch (6.1.1 (c) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Bumper damaged and likely to cause injury when grazed or contacted wheel arch (6.1.4 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear Brake lever has insufficient reserve travel (1.1.2 (a))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Hydraulic leak, but not excessive (8.4.1 (a) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Fluid leak, but not excessive (8.4.1 (a) (i))

Rear both rear wheel arches corrodeded

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Fluid leak, but not excessive (8.4.1 (a) (i))

Rear both rear wheel arches corrodeded

Nearside Headlamp aim too high (1.8)

Engine and body under trays fitted not allowing full inspection during the MOT

Power steering fluid level low, but not below minimum (2.3.1)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Oil leak

Under-trays fitted obscuring some underside components

bonnet pull handle missing

emissions to clean to test

near side rear brake pads wearing low

off side front tyre worn slightly on edges

rear brake application slightly uneven

An item not tested (Manual)

rear tyres worn on inner edges

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

exhaust rusty

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

exhaust rusty

long handbrake travel

rear pads worn

O/S/F Head light dim

Rear Tyre worn close to the legal limit (4.1.E.1)