2010 Toyota Auris

Central Front Undertray not fully secure (8.1.1 (b) (i))

Front Brake pad(s) wearing thin Both sides on limit (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Nearside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Central Front Undertray not fully secure (8.1.1 (b) (i))

Front Brake pad(s) wearing thin Both sides on limit (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material Both sides (1.1.11 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt both sides (2.1.3 (g) (i))

Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

general corrosion

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

park brake has little reserve travel

screw in nearside rear tyre

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Seat belt not functioning as intended (7.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

screw in nearside rear tyre

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front registration plate deteriorated but not likely to be misread (6.3.1d)