2012 Ford Mondeo

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Position lamp with a multiple light source up to 1/2 not functioning outer light dimmer (4.2.1 (a) (i))

Nearside Rear All position lamps with a multiple light source up to 1/2 not functioning outer light dimmer (4.2.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material coating bubble up (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

advise oil leak

Brake lever has insufficient reserve travel (1.1.2 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Position lamp with a multiple light source up to 1/2 not functioning outer light dimmer (4.2.1 (a) (i))

Nearside Rear All position lamps with a multiple light source up to 1/2 not functioning outer light dimmer (4.2.1 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material coating bubble up (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

advise oil leak

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Horn not working (7.7 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Zero Emitter, No Smoke readings available

Nearside Stop lamp(s) lens defective such that the emitted light is adversely affected (4.3.1 (b) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Direction indicator incorrect colour (4.4.3 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Direction indicator slightly discoloured (4.4.3 (a))

Tyre worn close to legal limit/worn on edge All (5.2.3 (e))

Zero Emitter, No Smoke readings available

Nearside Rear Trailing arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Rear Trailing arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

Zero Emitter, No Smoke readings available

Offside Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit Inner Edge (4.1.E.1)

Offside Rear Child Seat fitted not allowing full inspection of adult belt ()

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Front Wheel nut(s) missing (4.2.A.1e)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Nearside Headlamp aim too high and too far to the right. (1.8)

Offside Front one jet does not hit screen

Offside Headlamp aim too high and too far to the right. (1.8)

Rear Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front registration plate character(s) likely to be misread (6.3.4b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)