2013 Vauxhall Vivaro

Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Lower Suspension arm insecurely attached (5.3.3 (a) (i))

Nearside Front Upper Macpherson strut pin or bush excessively worn mounting bush (5.3.4 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Central Exhaust mounting defective (6.1.2 (a))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Outer Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge Edge (5.2.3 (e))

Offside Front Upper Suspension component mounting prescribed area damaged but not considered excessive Suspension turret worn by contact with spring (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened Axle (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Surface rust (6.2.2 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2.0 mm (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Suspension rod ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Surface rust (6.2.2 (d) (i))

Offside Rear Tyre worn close to legal limit/worn on edge 2.0 mm (5.2.3 (e))

Nearside Play in steering rack inner joint(s) ()

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

wipers smearing slightly

Headlamp aim not tested (1.8.A.1c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Brake pad(s) wearing thin outer pad (3.5.1g)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded 3x sections (3.6.B.2c)

wipers smearing slightly

Front brakes binding slightly

Nearside Front Tyre worn close to the legal limit measured at 2mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit measured at 2mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)