2008 Ford Ka

Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Axle swivel pins and bushes swivel pin and/or bush slightly worn Both rears (5.1.2 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened Fronts (1.1.14 (a) (ii))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Passenger seat mount (6.2.2 (d) (i))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Headlamp slightly loose

Nearside mirror loose

Nearside parking brake has poor effort

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Subframe mounting prescribed area is corroded but not considered excessive Front - all mounts corroded (5.3.6 (a) (i))

Valve stem slightly damaged Both fronts (5.2.3 (j))

Vehicle structure is corroded but structural rigidity is not significantly reduced Sill along vehicle and chassis at front (6.1.1 (c) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wing behind strut (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill to floor (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner wing behind strut (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner arch behind strut (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill end into arch (6.2.2 (d) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

slight exhaust blow

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

sills and underbody very rusty and weak

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

sills and underbody very rusty and weak

Front passenger door cannot be opened from inside the vehicle (6.2.B.1b)

Headlamp aim beam image obviously incorrect both (1.8.A.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim too low (1.8)

front discs worn

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front discs worn