1981 Ford Fiesta

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both rack ends

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Offside Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

both rack ends

Front Fuel system component leaking (7.2.3)

Front Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Stop lamp excessively damaged so that it is not visible from a reasonable distance (1.2.1d)

Nearside Rear Seat belt retracting mechanism defective (5.2.5b)

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Front Stop lamp excessively damaged so that it is not visible from a reasonable distance (1.2.1d)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Shock absorber has negligible damping effect (2.7.5)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Shock absorber has a slightly reduced damping effect (2.7.5)

Front front brake binding (3.7.B.1)

Front Horn not working (1.6.2a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Nearside Front Macpherson strut has excessive play in the sliding bush or gland (2.5.B.1b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Headlamp aim too low and too far to the right. (1.8)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Rear Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Rear Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Headlamp aim too low (1.8)

Nearside Rear wheel bearing has slight play (2.6.2)

OVER HEATING FAN NOT CUTTING IN

Offside Front Macpherson strut has slight play in the sliding bush or gland (2.5.B.1b)

Offside Rear wheel bearing has slight play (2.6.2)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a part missing (7.1.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front drive shaft coupling is insecure (2.5.C.1c)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear wheel bearing has excessive play (2.6.2)

Service brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe slightly corroded (3.6.B.2c)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

oil leak