2004 Honda CBR125R

Drive chain sprocket worn, but not excessively inner drive bushes (6.1.7 (c) (i))

clutch lever sticking

right hand handle bar end stop missing

Drive chain excessively loose (6.1.7 (c) (i))

Rear Brake excessively binding (1.2.1 (f))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Drive chain sprocket worn, but not excessively inner drive bushes (6.1.7 (c) (i))

clutch lever sticking

Exhaust noisy (8.1.1 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Front Brake binding but not excessively (1.2.1 (f))

Nearside Front Footrest insecure (6.2.12 (a))

Offside Front Footrest insecure (6.2.12 (a))

Offside Front Steering operation impeded by a fairing (2.1.4 (e))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Drive chain slightly tight (6.1.7 (k) (i))

Exhaust noisy (8.1.1 (a))

Exhaust silencer slightly loose (8.1.1 (b) (i))

Front Brake binding but not excessively (1.2.1 (f))

Front Inner Brake pad(s) close to minimum limit (1.1.13 (a))

Offside Front handle bar grip is worn

main beam switch is sticking

Offside Front flasher lamp taped on

Front Brake disc(s) has slight run out (3.2.A1m)

Front Plate brake test indicates a slightly juddering brake (3.3.B1b)

Rear Brake fluid reservoir fluid level low (3.2.B1d)

Front Floor brake test indicates a severely juddering brake (3.3C2d.)

Front Floor brake test indicates a slightly grabbing brake (3.3.C2d)

rear brake slightly spongy (new pads?)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Drive chain worn but not considered excessive (6.2.1e)

Rear Drive chain worn but not considered excessive (6.2.1e)

Centre Rear Lower Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii)) DANGEROUS

Offside Front Upper Front shock absorber has light misting of stanchion (2.3.3)

Front Roller brake test indicates a binding brake (3.3.A1a)

Rear Roller brake test indicates a binding brake (3.3.A1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))