2005 Mazda MX-5

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Suspension arm ball joint dust cover severely deteriorated both (5.3.4 (b) (i))

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp not working on main beam (1.7.5a)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Headlamp not working on dipped beam x2 (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Body has slight corrosion sills (6.1.B.2)

Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Body has a projection caused by damage sill (6.1.C.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front brake caliper leaking (3.6.A.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Body has a projection caused by damage sill (6.1.C.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

abs wires nsf osf insecure

brake warning light on

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

engine management light on

front discs corroded

rear pads low

front brake discs slightly corroded on inner faces

hand brake travel getting long

rear brakes binding slightly

Front Brake pad(s) wearing thin (3.5.1g)

wiper blades split but clearing screen