2006 Toyota Aygo

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Exhaust mounting defective mounting bend (6.1.2 (a))

Vehicle structure is repaired but structural rigidity is not significantly reduced under body (6.1.1 (d) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

general underbody corroded

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear under vehicle general corrosion

Offside Rear Service brake grabbing severely (1.2.1 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear under vehicle general corrosion

Nearside seal damaged

Offside Front Macpherson strut ball joint has slight play (5.3.4 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Suspension arm damaged but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm damaged but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Emissions not tested major leak of gases from exhaust, unable to get a reading to preform a BET test (8.2.1.2 (d))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Rear Exhaust silencer likely to become detached (8.1.1 (b) (ii)) DANGEROUS

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Anti-roll bar linkage ball joint likely to become detached (5.3.4 (a) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced inner sill corroded (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner / outer sill area (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner / outer sill area (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all main pipes greased (1.1.11 (c))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced inner outer sill edge (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced inner outer sill edge (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing shock absorber corroded (5.3.2 (b))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material brake pipe from flexy hose to wheel slightly corroded (1.1.11 (c))

Offside Rear Shock absorbers has slight external damage to the casing shock absorber corroded (5.3.2 (b))

Rear rear axle corroded

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Shock absorbers has slight external damage to the casing shock absorber corroded (5.3.2 (b))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material brake pipe from flexy hose to wheel slightly corroded (1.1.11 (c))

Offside Rear Shock absorbers has slight external damage to the casing shock absorber corroded (5.3.2 (b))

Rear rear axle corroded

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Emissions not tested (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside rear brake binding (3.7.B.1)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

wear in front brake discs

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear wheel bearing has slight play (2.6.2)