2007 Mercedes-benz Clk

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both front D bushes (5.3.4 (a) (i))

Shock absorbers has a reduced damping effect all (5.3.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Anti-roll bar pin or bush worn but not resulting in excessive movement both front D bushes are worn (5.3.4 (a) (i))

Offside Front seat does not tilt forward

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Position lamp showing white light to the rear (4.2.3 (a) (ii))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Anti-roll bar pin or bush worn but not resulting in excessive movement both front D bushes are worn (5.3.4 (a) (i))

Headlamp has a product on the lens but not seriously reducing light output both front (4.1.4 (b))

Offside Front Tyre slightly damaged/cracking or perishing tyre is also worn (5.2.3 (d) (ii))

Offside Front seat does not tilt forward

Oil leak, but not excessive (8.4.1 (a) (i))

engine oil is low

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement inner D bush (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement inner D bush (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement inner D bush (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement inner D bush (5.3.4 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Front Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Brake pipe excessively corroded near fuel tank (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Brake pipe slightly corroded front to rear (3.6.B.2c)

undertrays and engine covers fitted

Nearside Front coil spring broken (2.4.C.1a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Side repeater not working (1.4.A.2c)

Brake pipe slightly corroded front to rear (3.6.B.2c)

undertrays and engine covers fitted

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front suspension has excessive play in a lower suspension ball joint rear most (2.5.B.1a)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Lower Suspension arm has excessive play in a ball joint front arm (2.4.G.2)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust centre silencer mounting broken and missing

Slight noise from nearside parking brake when applied

Under-trays fitted obscuring some underside components

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Under-trays fitted obscuring some underside components

engine oil dipstic missing

Offside Front coil spring incomplete (2.4.C.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS