2001 Toyota Yaris

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

hand brake travel

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OSR inner wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength OSR inner wheel arch (top of inner wheel arch) (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

hand brake travel

head lamp aim glazed

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive under body is very corroded (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive under body is corroded (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive under body is corroded (5.3.6 (a) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear inner wheel arches slight corrosion

under body corroded

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

handbrake travel high

rear inner wheel arches slight corrosion

under body corroded

handbrake lever near end travel

under body corroded

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

under body corroded

Nearside Rear Parking brake inoperative on one side low (1.4.1 (a))

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

hand brake close to end travel

under body corroded

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front anti bar link rubber perrishing

General underbody corrsion

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

osf tyre worn on outter edge

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Parking brake lever has little reserve travel (3.1.6b)