2003 Toyota Yaris

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Outer Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Rear Rear fog lamp does not emit a steady red light (4.5.4 (a))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement BOTH SIDES (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened BOTH (1.1.14 (a) (ii))

Rear Fuel filler kneck slightly corroded

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Rear Fuel Pipe/s corroded ()

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill area (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill area (5.3.6 (a) (i))

rear fuel filler neck corroded

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill area (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill area (5.3.6 (a) (i))

hand brake has limited reserve travel

n.s.f and o.s.f head lamps tarnish (not affecting beam image)

rear fuel filler neck corroded

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

all steering and suspension bushes to crack and deteriorate and wear

both front light unit lens are starting to mist up and deteriorate

exhaust is starting to corrode and deteriorate

floor panels and chassis rails and inner sills and rear suspension mountings are starting to corrode surface rust

travel in hand brake lever

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Front brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Offside Rear Nail in tyre ()

all steering and suspension bushes to crack and deteriorate and wear

both front light unit lens are starting to mist up and deteriorate

exhaust is starting to corrode and deteriorate

floor panels and chassis rails and inner sills and rear suspension mountings are starting to corrode surface rust

travel in hand brake lever

Nearside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

both front tyres are starting to wear on edges

exhaust is starting to corrode and deteriorate

front anti roll bar bushes are starting to deteriorate

front anti roll bar bushes are starting to deteriorate

some steering and suspension bushes are starting to deteriorate

travel in hand brake lever

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Registration plate lamp not working (1.1.C.1d)

both front tyres are starting to wear on edges

exhaust is starting to corrode and deteriorate

front anti roll bar bushes are starting to deteriorate

front anti roll bar bushes are starting to deteriorate

some steering and suspension bushes are starting to deteriorate

travel in hand brake lever

exhaust is starting to corrode and deteriorate

some steering and suspension bushes are starting to deteriorate

travel in hand brake lever

Nearside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Front constant velocity joint is excessively worn (2.5.C.1b)

exhaust is starting to corrode and deteriorate

some steering and suspension bushes are starting to deteriorate

travel in hand brake lever

all tyres are starting to wear

n/s/r tyre cracked

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

coil spring corroded (2.4.C.1b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear coil spring corroded (2.4.C.1b)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

FRONT ANTI ROLLBAR DROPLINK BUSHES HAVE PERISHED, REAR SUBFRAME MOUNT BUSH BONDINGS HAVE BEGUN TO PERISH & EXHAUST IS HEAVILY CORRODED. Thanx.

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)