2005 Kia Sorento

Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Jacking point rusted through. (6.1.1 (c) (i))

Offside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Jacking point rusted through. (6.1.1 (c) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Side repeater slightly discoloured (4.4.3 (a))

Offside Side repeater slightly discoloured (4.4.3 (a))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills bothsides (5.3.6 (a) (i))

offsides/nearside side skirts fitted unable to inspect outer sills

Front Headlamp aim too high bothsides (4.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sills bothsides (5.3.6 (a) (i))

offsides/nearside side skirts fitted unable to inspect outer sills

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

oil leak from oil filter

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Stop lamp not working (1.2.1b)