2006 Ford Ka

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))

Front Inner Brake pad(s) less than 1.5 mm thick both (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Engine oil leak

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Central Exhaust mounting defective (6.1.2 (a))

Engine oil leak

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

engine has slight oil leak

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive rear axle mounting ( double skinned) (2.4.A.3)

Offside Rear chassis corroded near exhaust mounting

Main beam 'tell-tale' not working (1.7.4c)

Nearside Headlamp aim too low and too far to the right. (1.8)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear fuel filter insecure

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive rear axle mounting ( double skinned) (2.4.A.3)

Offside Rear chassis corroded near exhaust mounting

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn close to the legal limit worn on inner edge (4.1.E.1)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

nearside front sill area has surface rust

offside front tyre wearing from inside edge

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

general all round surface corrosion

unable to fully inspect welding repairs as covered in underseal

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Headlamp aim too far to the right (1.8)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear position lamp(s) not working (1.1.A.3b)

general all round surface corrosion

unable to fully inspect welding repairs as covered in underseal

Nearside Headlamp aim too low (1.8)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

general all round surface corrosion

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Headlamp aim too low (1.8)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front coil spring incomplete (2.4.C.1a)