2004 Suzuki GZ125

Front Wheel spoke slightly corroded (5.2.2 (d))

Rear Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Wheel corroded but not to excess (5.2.2 (c) (i))

Rear Wheel spoke slightly corroded (5.2.2 (d))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Drive chain worn to excess (6.1.7 (c) (i))

Rear Drive chain sprocket worn to excess (6.1.7 (c) (i))

Front Wheel spoke slightly corroded (5.2.2 (d))

Rear Motorcycle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Wheel corroded but not to excess (5.2.2 (c) (i))

Rear Wheel spoke slightly corroded (5.2.2 (d))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Headlamp aim too high (4.1.2 (a))

Front Wheel spoke slightly corroded (5.2.2 (d))

Rear Wheel spoke slightly corroded (5.2.2 (d))

Handlebar slightly corroded. Corrosion starting underneath (2.1.1b)

Motorcycle structure slightly corroded Frame rails under engine corroding (6.1.1a)

Drive chain excessively loose (6.2.1d)

Rear Drive chain sprocket carrier worn to excess (6.2.1e)

Handlebar slightly corroded. Corrosion starting underneath (2.1.1b)

Motorcycle structure slightly corroded Frame rails under engine corroding (6.1.1a)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust is leaking and excessively noisey (7.1.1b)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Front shock absorber seal failed and leaking oil (2.3.3)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust excessively deteriorated joint to rear silencer (7.1.1a)

Exhaust is leaking and excessively noisey joint to rear silencer (7.1.1b)

Nearside Front Front shock absorber seal failed and leaking oil fork (2.3.3)

Offside Front Front shock absorber seal failed and leaking oil fork (2.3.3)

Fork stanchions starting to pit

Headlamp aim too high (1.6)

front brake binding slightly

Motorcycle structure slightly corroded (6.1.1a)

Nearside Front suspension assembly slightly corroded. (2.3.1)

Offside Front shock absorber has light misting of stanchion (2.3.3)

Offside Front suspension assembly slightly corroded. (2.3.1)

Rear suspension component slightly corroded. (2.4.A.1a)

Front Brake pad(s) contaminated by oil or grease (3.2.A1k)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Offside Front shock absorber has light misting of stanchion (2.3.3)

both tyres were flat

tyres starting to perish

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))