2005 Mazda MX-5

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Outer & under sill section excessively corroded (7.1.1 (a) (i))

Nearside Front Upper Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected Suspension arm area (5.3.6 (a) (ii)) DANGEROUS

Front Lower Suspension arm corroded but not seriously weakened Both (5.3.3 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive Front anti roll ,bar both mounting areas (5.3.6 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Various section of under body (6.1.1 (c) (i))

Offside Front Shock absorber casing severely corroded

Offside Rear Shock absorber casing severely corroded

Rear Suspension arm corroded but not seriously weakened All (5.3.3 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Rear Brake pipe excessively corroded link brake pipe (1.1.11 (c))

Nearside Front Upper Anti-roll bar linkage ball joint likely to become detached detached. (5.3.4 (a) (ii)) DANGEROUS

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill/floor pan corroded within drivers lower belt mounting (7.1.1 (a) (i))

Offside Front Lower Anti-roll bar pin or bush likely to become detached Detached from mounting (5.3.4 (a) (ii)) DANGEROUS

Rear Inner Brake pad(s) wearing thin pads on/near minimum thickness (3.5.1g)

Nearside Rear Anti-roll bar linkage insecure broken away (2.4.G.1)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Rear Inner Brake pad(s) wearing thin pads on/near minimum thickness (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened inner faces left and right hand (3.5.1i)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)