2005 Toyota Land Cruiser

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced coil spring mount (6.1.1 (c) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced trailing arm mount (6.1.1 (c) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced upper shocker mount (6.1.1 (c) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Hydraulic brake calliper leaking bleed nipple (1.1.16 (b) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Panard rod mount (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced suspension arm mount (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced trailing arm mount (6.1.1 (c) (i))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases Rear box (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill /body mount (7.1.1 (a) (i))

Offside Front Hydraulic brake calliper leaking (1.1.16 (b) (i))

Nearside Front Inner Drive shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Vehicle structure is so weakened by corrosion within 30cm of a towbar mounting, the towbar is likely to become detached chassis rear cross member (6.1.6 (i) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases rear box (6.1.2 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing cracking in side wall (5.2.3 (d) (ii))

Offside Front Upper Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Suspension rod attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Suspension rod attachment bracket/mounting corroded but its strength is not seriously reduced (5.3.3 (b) (i))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Brake pipe excessively corroded corroded (1.1.11 (c))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm front bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear brake pipes corroded (1.1.11 (c))

Nearside Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive spring mounting (5.3.6 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive spring mounting (5.3.6 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Nearside Rear Registration plate lamp likely to become detached (4.7.1 (c) (ii))

Central Front Inner Oil leak front propshaft flange seal slight oil leak

Nearside Front Brake pipe slightly corroded and off side front (3.6.B.2c)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak gear box

Nearside Front Brake pipe slightly corroded and off side front (3.6.B.2c)

Nearside Headlamp aim too high and offside (1.8)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Oil leak gear box

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

general under body corrosion

headlamps just in aim

items removed from driver's view

rear self levelling motor corroded and insecure

Items removed from driver's view prior to test

Nearside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

general under body corrosion

Items removed from driver's view prior to test

Rear Brake pad(s) wearing thin (3.5.1g)

general under body corrosion

Offside Rear Shock absorber has a light misting of oil (2.7.3)

osf floor mat insecure

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)