2008 Peugeot 107

Brake lever has insufficient reserve travel (1.1.2 (a))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Emissions unable to be completed (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Horn not working (7.7 (a))

Nearside Brake pipe excessively corroded Front to rear (1.1.11 (c))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Sill (6.2.2 (d) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Axle mounting (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Axle mounting (5.3.6 (a) (i))

Offside Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner and outer sill (6.2.2 (d) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Brake pipe leaking on a hydraulic braking system Front to rear (1.1.11 (b) (ii)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge outer edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material front to rear slightly corroded before flexi (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside outer sill corroded

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill and under sill (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material slightly corroded before flexi (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Emissions not tested (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Horn not working (7.7 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake inoperative on one side (1.4.1 (a))

Exhaust has a minor leak of exhaust gases joint before back axle (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Exhaust corroded

Oil leak possibly sump gasket ()

Nearside Front Inner Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear tyre is at 2mm and slight cracking

Offside Front Inner Brake hose has slight corrosion to ferrules (3.6.B.4e)

Offside Rear tyre is at 2mm and slight cracking (rear tyres are 2010)

application on rear wheels is uneven would advise brakes are adjusted