2008 Peugeot 107

Front Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Lower Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick both side (1.1.13 (a) (ii)) DANGEROUS

Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm both side (5.2.3 (e)) DANGEROUS

Nearside Rear Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Offside Rear Lower Vehicle structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired (6.2.2 (d) (ii)) DANGEROUS

Offside Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Brake lining(s) wearing thin both side (1.1.13 (a) (ii))

Front Headlamp not working on dipped beam both bside (4.1.1 (a) (ii))

Offside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Front Brake pad(s) less than 1.5 mm thick both side (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Brake lining(s) wearing thin both side (1.1.13 (a) (ii))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)