2009 Peugeot 107

Central Suspension component mounting prescribed area is corroded but not considered excessive inner floor to sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

boot floor damaged

Central Suspension component mounting prescribed area is corroded but not considered excessive inner floor to sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

boot floor damaged

Stop lamp(s) all not working (4.3.1 (a) (iii))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides of car (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin All (1.1.13 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear pipe, at rear. (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive beam mounting area, beyond repaired section. (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive beam mounting area (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength beam mounting area. Marked in yellow (5.3.6 (a) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill. Marked in yellow. (7.1.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides of car (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin All (1.1.13 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear pipe, at rear. (1.1.11 (c))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive beam mounting area (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe excessively corroded Main Brake Pipe (1.1.11 (c))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)