2009 Honda Accord

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Anti-roll bar linkage ball joint excessively worn Both (5.3.4 (a) (i))

Rear Anti-roll bar linkage pin or bush excessively worn (D Bush) (5.3.4 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Front Macpherson strut mounting corroded but not seriously weakened Both (5.3.3 (b) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Both side (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both side (5.3.6 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Windscreen wiper blade defective (3.4 (b) (i))

Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust fumes entering cabin (6.1.2 (b) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Bumper insecure (6.1.4 (a) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Service brake excessively fluctuating (1.2.1 (e))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Bumper insecure (6.1.4 (a) (i))

Windscreen washer not working both (3.5 (a))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Nail in tyre

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Brake disc worn, pitted or scored, but not seriously weakened Front and rear (1.1.14 (a) (ii))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output Both sides (4.1.4 (b))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt Both sides (2.1.3 (g) (i))

Nearside Front Play in steering rack inner joint(s)

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing Sidewalls (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement De-bushes (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps Both lamps (4.7.1 (b) (ii))

Brake disc worn, pitted or scored, but not seriously weakened Front and rear (1.1.14 (a) (ii))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output Both sides (4.1.4 (b))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Both sides (5.3.4 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt Both sides (2.1.3 (g) (i))

Nearside Front Play in steering rack inner joint(s)

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing Sidewalls (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement De-bushes (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both side D bushes (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Service brake fluctuating, but not excessively Both (1.2.1 (e))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Service brake fluctuating, but not excessively Both (1.2.1 (e))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a major leak of exhaust gases beneath the exhaust manifold is an exhaust leak, suspect EGR pipework, but need to investigate to be sure (6.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Nearside Front Upper Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Front Valve stem seriously damaged (5.2.3 (j)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge tyre tread getting low, and edges have very heavy wear, strongly advise replacement (5.2.3 (e))

Offside Front Nail in tyre nail in tyre and tyre tread getting low, and edges have very heavy wear, strongly advise replacement

Offside Front Tyre obviously under inflated (5.2.3 (l))

due to very odd tyre wear, advise repair of suspension, replacement tyres followed by wheel alignment is recommended

headlamp lenses are hazey

under trays loose

Offside Front tyre valve is torn at the bottom

Nearside Front Suspension arm attachment bracket/mounting insecure split pin missing from lower ball joint (5.3.3 (a) (i))

Nearside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Suspension arm attachment bracket/mounting insecure split pin missing from lower ball joint (5.3.3 (a) (i))

Offside Front tyre valve is torn at the bottom

Nearside Rear Child Seat fitted not allowing full inspection of adult belt

Central Upper Stop lamp not working (1.2.1b)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp aim not tested (1.8.A.1c)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pad(s) less than 1.5 mm thick both sides, inner pads (3.5.1g)

Nearside Rear Child Seat fitted not allowing full inspection of adult belt

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Lower Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Child seat fitted not allowing full inspection of adult belt

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)