2001 Toyota Yaris

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases in between centre pipe and back box (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Nearside Rear panel hole

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Nearside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Nearside Rear Outer Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting wheel arch (6.2.2 (d) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount (5.3.6 (a) (i))

Nearside Rear Suspension spring mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Nearside Rear panel hole

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive trailing arm mount (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside front brake recording little or no effort (3.7.B.5a)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Parking brake lever has no reserve travel (3.1.6b)

Shock absorber has a serious fluid leak o/s front (2.7.3)

Windscreen washer provides insufficient washer liquid n/s front (8.2.3)

Windscreen washer provides insufficient washer liquid o/s front (8.2.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

coil spring corroded (2.4.C.1b)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Inner Front brake disc slightly pitted (3.5.1h)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)