2002 Fiat Seicento

advise corrosion underneath

Nearside Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i))

Offside Front Brake pipe excessively corroded os front to rear (1.1.11 (c))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting jacking point (6.2.2 (d) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

advise corrosion underneath

Offside Front Outer advise corrosion osf jacking point

Offside Front direction indicator slight loose

Offside Front shock absorber corroded

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front direction indicator slight loose

Offside Front shock absorber corroded

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Oil leak

drive shaft gaiters are perished

n/s front tyre inner side wall is badly perished

suspension arms are rusted

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Offside front brake binding (3.7.B.1)

Oil leak

drive shaft gaiters are perished

n/s front brake is slower to operate

n/s front shock absorber damping is very poor

n/s front tyre inner side wall is badly perished

n/s hand brake performance is low

suspension arms are rusted

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside rear brake binding (3.7.B.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)