2005 Peugeot 1007

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Brake pipe corroded, covered in grease or other material various pipes (1.1.11 (c))

Suspension arm ball joint has slight play both front (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front and back (5.3.6 (a) (i))

Nearside Front Seat belt installation causes a three point belt lap section to be incorrectly positioned across the occupant (10.1 (u))

Nearside Front Seat belt installation causes a three point belt lap section to be incorrectly positioned across the occupant (10.1 (u))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Offside Headlamp aim too low (4.1.2 (a))

Central Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

clutch

clutch

Play in steering rack inner joint(s)

front tyres worn on shoulders and approx 3.5/4mm

nearside front wheel bearing slightly rough when rotated

nearside rear tyre deforming slightly

rear exhaust corroded

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)