2010 Audi A6

Nearside Front Nail in tyre ()

Offside Front washer jet partly blocked

Nearside Front Nail in tyre ()

Offside Front washer jet partly blocked

Offside Headlamp aim too low (4.1.2 (a))

Front heat shield damaged

Central Rear Seat belt buckle not functioning as intended (7.1.2 (d))

Front Anti-roll bar linkage pin or bush excessively worn Both (5.3.4 (a) (i))

Front Undertray insecure (8.1.1 (b) (i))

Headlamp cleaning device for LED or HID headlamp inoperative (4.1.6 (a) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front heat shield damaged

Nearside driveshaft fouling sound deadening material

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords tyre wearing very close to the limit/cut (4.1.D.1a)

Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Tyre worn close to the legal limit both (4.1.E.1)

Offside Rear Tyre worn close to the legal limit uneven inner tread (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Offside Registration plate lamp not working (1.1.C.1d)