2003 Kia Carens

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Wheel arch (6.1.1 (c) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D bushes (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases center pipe to back box (6.1.2 (a))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Front passenger door cannot be opened from outside the vehicle (6.2.3 (a))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Driver's door cannot be opened from outside the vehicle (6.2.3 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Upper Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced Wheel arch (6.1.1 (c) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D bushes (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases center pipe to back box (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate insecure but not likely to fall off (0.1 (a))

Front Tyre worn close to legal limit/worn on edge Both (5.2.3 (e))

Nearside Rear Body corrosion or condition

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust system not adequately supported rear mounting broken (7.1.1)

Nearside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Outer door handle missing but still able to open door

Brake pipe excessively corroded both front to rear at rear (3.6.B.2c)

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

rear exhaust braket is broken at joint and joint is corroded

OSR tyre wall has perrished

Offside Front suspension ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Rear Brake pad(s) wearing thin (3.5.1g)