2004 Mercedes-benz Vito

Chip in screen

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Chip in screen

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

rear parking brake recording little or no effort (3.7.B.6a)

Central Rear Brake pipe excessively corroded both (3.6.B.2c)

Nearside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Headlamp aim too low (1.8)

Offside Rear fog lamp not working (1.3.2b)

Offside Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

lower inner back pannel corroded

exhaust pipe corroded

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

exhaust pipe corroded

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

o/s/r tyre cracking slightly on side wall

handbrake lever has slight reserve travel. underbody starting to rust. oil leak. all brake pipes coated with under sealant.

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake pipes corroding

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Registration plate lamp not working (1.1.5c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)