2005 Mazda MX-5

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced Inner sill (7.1.1 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Nearside Front Fog light missing

Nearside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Upper Anti-roll bar linkage ball joint has slight play Locking nut slightly lose (5.3.4 (a) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive Outer sill (7.1.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin Both N/S + O/S (1.1.13 (a) (ii))

Nearside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill before rear wheel (6.1.1 (c) (i))

Offside Rear Lower Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill before rear wheel (6.1.1 (c) (i))

Front Brake pad(s) wearing thin Both N/S + O/S (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive near anti roll bar mounting inside wheel arch (2.4.A.3)

Suspension component mounting prescribed area is corroded but not considered excessive both sills at rear (2.4.A.3)

Offside Front outter tyre wall cracked (no cords showing)

o/s front tyre side wall cracking

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

o/s front tyre side wall cracking

Items removed from driver's view prior to test

Offside Rear Anti-roll bar linkage insecure (2.4.G.1)

Items removed from driver's view prior to test

Nearside Rear Anti-roll bar linkage insecure (2.4.G.1)