2006 Toyota Aygo

Headlamp aim unable to be tested (4.1.2 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

front exhaust mounting missing

general corrosion of chassis and suspension components

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Sill (6.1.1 (c) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

n/s front tyre worn on inside edge

rear tyre,s cracking in tread

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

n/s front tyre worn on inside edge

rear tyre,s cracking in tread

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc slightly pitted (3.5.1h)

Rear Bootlid cannot be secured in the closed position (6.4.1)