2006 Kia Sportage

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Offside Side repeater slightly discoloured (4.4.3 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Seat belt buckle slightly damaged centre (7.1.2 (d))

Driver's view of the road through the swept area of the windscreen significantly affected by an obstruction sun visor (3.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases front pipe/ catalytic converter joint (6.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Seat belt buckle slightly damaged centre (7.1.2 (d))

Central Rear Seat belt buckle slightly damaged cover missing (7.1.2 (d))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone - front inner bush debonded/deteriorated/play (5.3.4 (a) (i))

Nearside Rear tyre worn on the outer edge

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Tyre slightly damaged/cracking or perishing both in treads (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Rear Seat belt buckle slightly damaged (7.1.2 (d))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Macpherson strut mounting likely to fail top mounting collapsed (5.3.3 (b) (ii)) DANGEROUS

Central Rear Seat belt buckle slightly damaged (7.1.2 (d))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Rear Seat belt buckle slightly damaged cover missing (7.1.2 (d))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Central Rear seat belt buckle incomplete

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement wishbone - front inner, as marked (2.4.G.2)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Central Rear seat belt buckle incomplete

Nearside Rear Tyre worn close to the legal limit worn outer edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit worn inner edge (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rear center seat belt buckle damaged

Nearside Registration plate lamp not working (1.1.C.1d)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Nearside Rear Shock absorber has negligible damping effect (2.7.5)

Offside Front Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)