2006 Mazda 5

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

underside corrosion

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

underside corrosion

Front Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Shock absorbers has a reduced damping effect all (5.3.2 (d))

underside corrosion

Front Lower Suspension arm pin or bush excessively worn rear bushes both sides (5.3.4 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Lower Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Shock absorbers has a reduced damping effect all (5.3.2 (d))

underside corrosion

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Fuel tank exhaust shield missing where fitted as original equipment creating a risk of fire (6.1.3 (e)) DANGEROUS

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Front Headlamp aim too high (4.1.2 (a))

Brake pad(s) wearing thin Both rear (1.1.13 (a) (ii))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Windscreen wiper does not clear the windscreen effectively Both front (3.4 (b) (ii))

Brake pad(s) wearing thin All four (1.1.13 (a) (ii))

Nearside Front Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

both front's tyre edges worns

both rear tyres iner edges wornes