2008 Toyota Aygo

Child Seat fitted not allowing full inspection of adult belt ()

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Child Seat fitted not allowing full inspection of adult belt ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front both shock absorbers corroded but not seriously weakened

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Rear axle beam and all suspension components corroded but not seriously weakened

Rear Suspension component mounting prescribed area is corroded but not considered excessive beam axle mounting prescribed areas (5.3.6 (a) (i))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive beam axle mounting prescribed areas (5.3.6 (a) (i))

n/s headlamp has a poor beam image

very slight binding to o/s/f brake

Nearside Brake pipe corroded, covered in grease or other material front to rear.advise replacement asap (1.1.11 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim unable to be tested no beam image (4.1.2 (b))

Offside Front Suspension arm pin or bush likely to become detached lower arm,rear bush (5.3.4 (a) (ii)) DANGEROUS

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Brake pipe corroded, covered in grease or other material front to rear.advise replacement asap (1.1.11 (c))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Brake pipe corroded, covered in grease or other material to n/s rear flexi brake hose (1.1.11 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Brake pipe corroded, covered in grease or other material to n/s rear flexi brake hose (1.1.11 (c))

Nearside Rear brake binding slightly

rear sill sections corroded

rear subframe front outer mountings deteriorating

slight imbalance of rear brakes

Nearside Rear brake binding slightly

Registration plate lamp inoperative in the case of a single lamp or all lamps 2 (4.7.1 (b) (ii))

rear sill sections corroded

rear subframe front outer mountings deteriorating

slight imbalance of rear brakes

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

near side front tyre inner edge bald and wearing very close to legal limits, and off side front tyre inner edge worn low

rear of near side front to rear metal brake pipe rusting

screw in centre of off side rear tyre tread area

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

near side front tyre inner edge bald and wearing very close to legal limits, and off side front tyre inner edge worn low

rear of near side front to rear metal brake pipe rusting

screw in centre of off side rear tyre tread area

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both rear tyres perished and cracked outer edge

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside front to rear brake pipe at rear corroded

nsf tyre wearing on edges

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)