2004 Mercedes-benz Viano

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Nearside Rear Brake hose excessively damaged (1.1.12 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Underside of vehicle heavily corroded

Brake performance not tested (1.2.1 (g))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Cross member (5.3.6 (a) (i))

Rear Exhaust system insecure (6.1.2 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Underside of vehicle heavily corroded

Central Rear Upper Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

Front Windscreen damaged but not adversely affecting driver's view chip in zone a (3.2 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer arch corroded

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive arm mounting piont (5.3.6 (a) (i))

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive shock mounting area (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Outer arch corroded

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive arm mounting piont (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive shock mounting area (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking piont (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking piont (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Exhaust system insecure back exhaust broken (6.1.2 (a))

Rear Registration plate insecure (0.1 (a))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Central Rear Upper Stop lamp(s) light intensity obviously reduced (4.3.3 (a) (i))

Front Windscreen damaged but not adversely affecting driver's view chip in zone a (3.2 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Outer arch corroded

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive arm mounting piont (5.3.6 (a) (i))

Nearside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive shock mounting area (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Outer arch corroded

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive arm mounting piont (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive shock mounting area (5.3.6 (a) (i))

Central Rear Stop lamp has light sources not illuminating, but not more than 50% one led out (1.2.1b)

Nearside Front Upper Subframe mounting prescribed area is corroded but not considered excessive top of chassis leg corroded (2.4.A.3)

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

under body corroded and both middle out riggers corroded

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Outer Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Central Rear Stop lamp has light sources not illuminating, but not more than 50% one led out (1.2.1b)

Nearside Front Upper Subframe mounting prescribed area is corroded but not considered excessive top of chassis leg corroded (2.4.A.3)

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

under body corroded and both middle out riggers corroded

Body has slight corrosion under side (6.1.B.2)

Exhaust system not adequately supported (7.1.1)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings inner sill (6.1.B.2)

Body has slight corrosion under side (6.1.B.2)

Body has slight corrosion all over under body (6.1.B.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Rear Upper Vehicle structure has slight corrosion (6.1.B.2)

all brake pipes covered with black under seal obscuring pipes

under trays fitted obscuring some components

Nearside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill holed (6.1.B.2)

Nearside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill holed (6.1.B.2)

Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill holed (6.1.B.2)

Offside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill holed (6.1.B.2)

Offside Rear Upper Brake pipe excessively corroded (3.6.B.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Body has slight corrosion all over under body (6.1.B.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Upper Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Rear Upper Vehicle structure has slight corrosion (6.1.B.2)

all brake pipes covered with black under seal obscuring pipes

under trays fitted obscuring some components

Nearside Front Steering rack gaiter deteriorated (2.2.D.2d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Steering rack gaiter deteriorated (2.2.D.2d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Indicator switch insecure (1.4.A.1)

Engine covers fitted obscuring some components in the engine bay

Items removed from driver's view prior to test

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

N/S/F TYRE CUT OUT BAD ON OUTER EDGE / UNDER TRAY FITTED / SLIGHT CORRSION ON REAR DISCS / O/S/R BRAKE PIPE CORRODING / BRAKE PIPES BEEN GREASED UP / SLIGHT UNDER BODY CORRSION

Nearside Side repeater not working (1.4.A.2c)

N/S/F TYRE CUT OUT BAD ON OUTER EDGE / UNDER TRAY FITTED / SLIGHT CORRSION ON REAR DISCS / O/S/R BRAKE PIPE CORRODING / BRAKE PIPES BEEN GREASED UP / SLIGHT UNDER BODY CORRSION

Child seat fitted not allowing full inspection of adult belt

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Child seat fitted not allowing full inspection of adult belt

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n/s front tyre worn heavily on outer edge

Child seat fitted not allowing full inspection of adult belt

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

n/s front tyre worn heavily on outer edge

Inner Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)