2006 Toyota Dyna

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Outer Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pipe corroded, covered in grease or other material over axel (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Front Exhaust has a major leak of exhaust gases front pipe missing (6.1.2 (a))

Nearside Rear Outer Position lamp not working outline marker (4.2.1 (a) (ii))

Offside Fuel tank leaking (6.1.3 (b) (i))

Offside Rear Outer Position lamp not working outline marker (4.2.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sides cab (rear) (6.2.2 (d) (i))

Front Anti-roll bar linkage pin or bush excessively worn both sides (front bush) (5.3.4 (a) (i))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner step (6.1.1 (c) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security both sides cab (rear) (6.2.2 (d) (i))

Nearside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step (6.1.1 (c) (i))

Offside Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step (6.1.1 (c) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Rear position lamp(s) not working marker light (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Stop lamp not working (1.2.1b)

Nearside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Outer Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear exhaust mounting broken

Front Exhaust has a major leak of exhaust gases front pipe (7.1.2)

Nearside Rear Leaf spring fractured (2.4.B.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp shows direct white light to the rear (1.1.C.1f)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Registration plate lamp shows direct white light to the rear (1.1.C.1f)

Parking brake: efficiency below requirements (3.7.B.7)

turbo intecooler fins blocked with dirt

Nearside Headlamp aim too low (1.8)

Registration plate lamp shows direct white light to the rear (1.1.C.1f)