2008 Land Rover Range Rover Sport

Front Brake disc worn, but not excessively Both front brake discs (1.1.14 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material All rear Brake Pipes (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Wheel bearing has slight play Both Fronts (5.1.3 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Wheel bearing has slight play on the limit of requirement (5.1.3 (a) (i))

Rear Rear fog lamp slightly affected by the operation of another lamp (4.5.4 (b))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Sub-frame. brake pipe .all suspension fuel pipe corroded .

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Windscreen wiper blade insecure (8.2.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Rear fog lamp not working (1.3.2b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake fluid warning lamp illuminated (3.6.G.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Offside Air suspension has no suspension movement (2.4.D.5)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nail in offside front tyre

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Electronic stability system warning lamp does not illuminate (3.4.1b)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Nail in offside front tyre

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Play in steering rack inner joint(s)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Front registration plate incorrect (6.3.1a)

Rear registration plate incorrect (6.3.1a)

Service brake: efficiency below requirements (3.7.C.1a)

o/s/r break binding and grinding