2008 Toyota Aygo

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Nearside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

general under body rust

under components corroded

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear axle mountings corroded.

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill. (6.1.1 (c) (i))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear axle mountings corroded.

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Rear Exhaust has a minor leak of exhaust gases clamp (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill + chassie leg (5.3.6 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill + chassie leg (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill + chassie leg (5.3.6 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill + chassie leg (5.3.6 (a) (i))

near side rear brake pipe starting to corrode

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Both rear tyres are starting to perish.

O/s/f Tyre starting to perish.

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)