2011 Volkswagen Polo

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Headlamp lens slightly defective both sides (4.1.1 (b) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Rear Coil spring corroded (5.3.1 (b) (i))

Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 1.8mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge outer edge worn (5.2.3 (e))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm ball joint has slight play track rod inner ball joint (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicles internal headlight adjuster altered to recheck lights ()

battery slightly loose

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Coil spring corroded (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 1.8mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge outer edge worn (5.2.3 (e))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm ball joint has slight play track rod inner ball joint (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicles internal headlight adjuster altered to recheck lights ()

battery slightly loose

Offside Front Inner Drag link end ball joint has slight play inner rack end slight play (2.1.3 (b) (i))

foot brake slightly creeping down

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a minor leak of exhaust gases slight leak front pipe and rear box corroded and rattling inside box (6.1.2 (a))

Front advice foot brake slightly creeping down

Offside Front Drag link end ball joint has slight play inner rack end worn (2.1.3 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Central Front Exhaust has a minor leak of exhaust gases exhaust flexi has slight leak (6.1.2 (a))

Offside Front Drag link end ball joint has slight play (2.1.3 (b) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has ply or cords damaged (5.2.3 (d) (ii)) DANGEROUS

Central Front Exhaust has a minor leak of exhaust gases exhaust flexi has slight leak (6.1.2 (a))

Offside Front Drag link end ball joint has slight play (2.1.3 (b) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Play in steering rack inner joint(s) ()

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Parking brake lever has no reserve travel (3.1.6b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Play in steering rack inner joint(s) ()

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords cracked (4.1.D.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords cracked (4.1.D.1a)

Nearside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit 3mm (4.1.E.1)